Dual Stream Bluetooth Stereo Transmitter SENA SM10 Version 0.
| SM10 SENA www.senabluetooth.com Users Guide TABLE OF CONTENTS INTRODUCTION................................................................................................................................................................................. 3 USING THE SM10............................................................................................................................................................................... 4 Installation ..............................................
| SM10 INTRODUCTION The SENA SM10 is a Bluetooth dual stream audio adapter. Key Specifications: Bluetooth v2.
| SM10 USING THE SM10 Installation Use the mounting kit included to install SM10 on handle bar. Connect an audio device such as onboard motorcycle audio system, MP3 player or smart phone to the main port using 3.5mm jack cable. If any, connect GPS or radar detector to the auxiliary port using 3.5mm jack cable. * On the sample SM10 unit, the mounting kit does not fit tightly with SM10. This problem will be fixed in the next hardware version.
| SM10 Clearing the paring list (Factory Reset) 2. Power on the SM10, and press the Pairing button on the SM10 for 12 seconds until the Blue and Red LED is rapidly flashing. 3. Then within 10 seconds, press Pairing button to confirm reset. The SM10 will be restored to factory setting and returns to standby mode. 4. If you don’t press the Pairing button within 10 seconds, the reset attempt is canceled and the SM10 returns to standby mode.
| SM10 LED INDICATOR LED DESCRIPTION Slow Blue Flashing Standby or connected Slow Red Flashing Standby or connected (second headset) Rapid Blue Flashing Pairing Rapid Red Flashing Pairing (second headset) Blue Double Flashing Streaming Red Double Flashing Streaming(second headset) Note 1. Play/Pause/Track back/Track forward will be support correctly only when iPhone is connected to the main port. Play/Pause can be supported on some Android smart phone.
| SM10 CERTIFICATION AND SAFETY APPROVALS FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: - This device may not cause harmful interference, and - This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
