User's Manual

| PD10
4
USING THE PD10
Installation
Insert the PD10 into the audio connector of the Victory motorcycle.
Power ON & OFF
Turn the motorcycle main switch to ACC. ON or Ignition to power on the PD10. To power off, turn the switch to OFF. The audio
adapter does not have a power button.
Bluetooth pairing with a headset
The PD10 must be paired with a Bluetooth headset, SMH10 before use.
1. Turn on the headset SMH10. (Refer to the headset user guide)
2. Make the SMH10 into pairing mode (Refer to the headset User Guide)
3. Start the motorcycle engine to turn on the PD10 audio adapter.
4. The PD10 finds and connects the SMH10 headset nearby.
5. Once PD10 is connected to the SMH10, you can hear the music from the motorcycle stereo system automatically. Please
make sure that the motorcycle stereo system is already powered on beforehand.
Using with a headset
1. Turn on the SMH10 that is already paired with the PD10.
2. Turn the motorcycle main switch to ACC. ON or Ignition to turn on the PD10 audio adapter.
3. The PD10 automatically connects to the SMH10, and you will hear the music from the motorcycle stereo system.
4. If you don’t hear any sound, press the Jog Dial on the SMH10 for 1 second until you hear a beep. (Refer to the headset user
guide)
** Sena does not guarantee that PD10 supports all other Bluetooth headsets except for the SMH10.
Clearing the paring list (Factory Reset)
Power on the PD10 by switching on the motorcycle, and press the button on the PD10 for 10 seconds.