User's Manual

| SR10

For Wired Connection

1. Mobile phones must be connected to the AUX2 port for wired connection.

2. Other instructions are the same as for the wireless connection.

Reset to Factory Default Settings

1. To restore the SR10 to factory default settings, press and hold the Pairing Button for 12

seconds until the LED shows solid red and blue.

2. Within 5 seconds, press the Pairing Button again to confirm reset. The SR10 will be

restored to factory settings and switched off automatically.

3. If you don't press the Pairing Button within 5 seconds, the reset attempt is canceled and

the SR10 returns to stand-by-mode.

Fault Reset

IF the SR10 is not working properly or is in a faulty status for any reason, you may reset by

pushing the pin-hole reset button at the top of the SR10 main unit. Insert a paper clip into the

reset pin-hole and press the reset button for 1 second with light pressure. The SR10 will be

switched off. Turn the SR10 back on and try to use it again. However, this will not restore the

SR10 to factory default settings.