User's Manual

63
Figure 4-13 RC4 Cryptography configuration
4.2.6. Serial port parameters
To connect the serial device to the Pro Series serial port, the serial port parameters of the Pro Series
should match exactly to that of the serial device attached. The serial port parameters are required to
match this serial communication. The parameters required for the serial communication are: UART
type, baud rate, data bits, parity, stop bits, flow control DTR/DSR behavior and inter-character timeout.
z Baud rate
The valid baud rate for the Pro Series is as follows:
75, 150, 200, 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200, and
230400
The factory default setting is 9600.
z Data bits
Data bits can be between 7 bits and 8 bits. The factory default setting is 8 bits.
서식 있음: 글머리 기호 및
번호 매기기
삭제됨
:
삭제됨:
삭제됨:
삭제됨:
삭제됨: