User's Manual

34
3.5. SMTP Configuration
The Pro Series can send an email notification when the number of system log messages reaches to
certain value and/or when an alarm message is created due to an issue with serial port data. The user
must configure a valid SMTP server send these automatically generated emails. The Pro Series
supports three SMTP server types:
• SMTP without authentication
• SMTP with authentication
• POP-before-SMTP
These examples can be seen in Figure 3-3. Required parameters for each SMTP configuration
include:
• SMTP server IP address
• SMTP user name
• SMTP user password
• Device mail address
The device mail address specifies the sender’s email address for all log and alarm delivery emails.
SMTP servers often check only the sender’s host domain name of the email address for validity.
Consequently, the email address set for the device can use an arbitrary username with a registered
hostname (i.e. [e-mail]
or [e-mail]).
The SMTP user name and SMTP user password are required when either SMTP with authentication
or POP-before-SMTP mode is selected.
Figure 3-10 SMTP Configurations
서식 있음: 글머리 기호 및
번호 매기기
삭제됨: