User's Manual

33
SD Response
OK
Purpose
Change device name
Parameters
$string= New device name (Default=”PSDv3b-445566”)
Description
Parani-ESD can have a user friendly name to identify easily. The name allows 30 alpha-
numeric characters maximum.
Reference
AT+BTINFO?, AT+BTINQ?
Example
AT+BTNAME=”My-Parani-ESD”
B.3.28. AT+BTLPM,n
SD Response
OK
Purpose
Set low power mode
Parameters
n=0: Inactivate (Default)
n=1: Activate
Description
During no data transmission, Parani-ESD can be in low power mode to save the power
consumption. It takes a few seconds to wake up Parani-ESD in low power mode.
B.3.29. AT+DFU
SD Response
(Display garbage messages repeatedly)
Purpose
Device firmware update
Description
DO NOT use this command in console. Because the Parani-ESD enters into firmware
update mode, garbage messages will appear. This command is used by ParaniWIN’s
firmware update menu.
B.3.30. AT&V
SD Response
S0:m0;S1:m1; …Sn:mn
OK
Purpose
Display all the S-register
Description
All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
Reference
ATS
B.3.31. ATSnn? 
SD Response
value
OK