User's Manual

15
2.3.1 Using Serial Console
1) Connect the one end of the serial console cable to the serial port of the LS100W.
Figure 2-4. Connecting a serial console cable to the LS100W
2) Connect the other end of the cable to the serial port of user’s computer.
3) Slide Data/Console switch to Console side.
Figure 2-5. Data/Console switch of the LS100W
4) Run a terminal emulator program such as HyperTerminal. Set up the serial configuration
parameters of the terminal emulation program as follows:
9600 Baud rate, Data bits 8, Parity None, Stop bits 1, No flow control