User's Manual

13
2.2 Connecting the Hardware
This section describes how to connect the LS100W to the serial device for initial testing.
- Connect a power source to the LS100W.
- Connect the LS100W to a serial device through serial data cable.
2.2.1 Connecting the Power
Connect the power jack to the LS100W power plug using the DC power adapter included in the
package. If power is supplied properly, the [Power] LED lamp on the LS100W front panel will remain
solid red.
Figure 2-2. Connecting the Power to the LS100W
2.2.2 Connecting to the Wireless LAN
There is built-in 802.11b Wireless LAN module in the LS100W. When power is connected correctly,
the module will automatically search for the Wireless LAN access point, and then try to connect to the
LAN access point. If the Wireless LAN cable is properly connected to the Wireless LAN access points,
the LS100W will have a valid connection to the Wireless LAN network and indicates that valid
connection with the following indications:
- The [Link] LED lamp on the LS100W front panel remains solid orange.
- The [Act] LED lamp on the LS100W front panel continuously blinks to indicate the transfer of the
incoming and outgoing Wireless LAN packets.