User's Manual

XXXXXEVBUM
PRE-PUBLICATION COPY - NOT FOR DISTRIBUTION TO CUSTOMERS - PROPRIETARY
18. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
19. Do not attempt to modify this product.
Doing so could result in personal injury and/or product failure.
20. Operate this product within its specified operating temperature range.
21. Protecting Against Electrostatic Discharge
Static electricity can harm delicate components inside the system.
To prevent static damage, discharge static electricity from your body
before touching any of the electronic components, such as Antenna, USB and Ethernet connectors. This can be done by
periodically touching an unpainted metal surface on the chassis.
The following steps can also be taken prevent damage from electrostatic discharge (ESD):
21.1. When unpacking a static-sensitive component from its shipping carton,
do not remove the component from the antistatic packing material
until ready to install the component in the system.
Just before unwrapping the antistatic packaging,
be sure to discharge static electricity from your body.
21.2. When transporting a sensitive component,
first place it in an antistatic container or packaging.
21.3. Handle all sensitive components in a static-safe area.
If possible, use antistatic floor pads, workbench pads and an antistatic grounding strap.
22. Equipment intended for installation in Restricted Access Location
WARNING:
No user-serviceable parts inside.
Refer all servicing to qualified service personnel.
The safety certifications do not apply when the operating voltage is changed from the factory setting.
SPSPRDR1-8 is with compliance to IEC/EN/UL/CSA 60950 "Safety of information technology equipment"
is one of the world’s most widely-used electrical product safety standards.
Thousands of manufacturers rely on this standard to show that their products meet the safety requirements
for markets around the world.
It is one of the relatively few standards to be harmonized by standards-writing bodies globally
to make the process as efficient as possible for manufacturers.
Caution according to FCC Rule part 15.21