Specification Sheet

Check local VOC

regulations to ensure

compliance of all

products in your area.

SEM Products, Inc.

1685 Overview Dr. Rock Hill, SC 29730

866.327.7829

semproducts.com

HANDLING AND APPLICATION

PREPARATION:

1. Clean with SEM Solve or XXX Universal Surface Cleaner.

2. For best results, prime surface with Metalock

DTM High Build Primer or World Class

DTM Primer,

according to directions. Sand with P400 – P600 grit.

MIXING:

Shake or stir thoroughly. Mix by volume:

4 Parts 1 Part 1 Part

Hot Rod Black Hot Rod Catalyst Hot Rod Reducer

Note: Use of additives other than Hot Rod Catalyst and Hot Rod Reducer are not recommended and will affect both

the appearance and performance of Hot Rod Black.

APPLICATION:

Set air pressure to: 40 - 45 psi for non-HVLP

8 - 10 psi at the cap for HVLP equipment

1. Use a gun equipped with a 1.3 - 1.4 nozzle. Spray one medium-wet coat keeping the gun 5 - 7" from the

substrate and minimum overlap of 75%. Allow to ﬂash dry, approximately 10 – 15 minutes.

2. Spray a second identical medium-wet coat and allow an additional 30 minutes before baking for 30 minutes

at 120°F (49°C), or air dry for 16 hours.

Note: Always spray a test panel to ensure desired gloss level. Variations in application, temperature, and gun set up

can affect the ﬁnal gloss of Hot Rod Black.

Do not recoat after panel has been baked or air-dried without ﬁrst sanding with P400 – 600 grit.

CARE:

Do not buff or polish. When washing is necessary, use a mild soap and dry immediately with a soft cloth or

chamois. To detail, use a microﬁber or other soft towel and a dedicated matte ﬁnish spray wax or detailer. Always

test in an inconspicuous area ﬁrst.

CLEANUP:

Use appropriate cleaning materials compliant with VOC regulations in your area.