Instruction Manual

18
Caterpillar: Non-Confidential
maintain a safe distance from the battery when
connecting.
 Pay attention not to allow the boosting
cable clips touch with each other or let the clip
touch to the machine when removing the
boosting cable.
Battery Charging
If the battery is not correctly charged, it may
have the possibility to explode. Therefore,
charge the battery according to the correct
procedure and following rules.
 Charge it under proper ventilation and
remove the battery cover. This allows the
hydrogen to diffuse and prevents explosion.
The air from the battery might cause explosive.
 Do not have fire or spark near the battery
and no smoking when charging.
 Set the voltage of charger to agree with
one of charged battery. If there is something
wrong with voltage, the charger will overheat
and may catch fire, which might cause
explosive.
 Connect the positive charging clip (+) to
the battery the positive terminal (+) and tighten
the two terminals.
 If the charging rate of battery is less than
1/10, charge it highly. Set the discrete value
under the battery rated volume. If the charging
current is too large, the electrolyte may leak or
evaporate, which could cause fire or explosion.
Towing
Pulling the Machine
Improperly towing a machine that or by using
an improper connection may result in damage
or death, so please obey by the following
regulations:
 Follow the towing instruction of the
“O&MM”.
 Wear leather gloves when using a steel
wire line.
 When doing the work together with the
other workers, make sure to use signals that
everyone knows before starting the work.
 If the machine engine cannot start or there
is a failure in the brake system, please contact
the Caterpillar (Qingzhou) Ltd. dealer to repair
the machine.
 It is very dangerous to pull a machine on
an incline. The worker should select an area
with a small gradient. If this does not exist,
then select the area with the smallest possible
gradient.
 If using the machine to tow another
machine that has failed, the steel wire line
must be strong enough to support the failed
machine’s weight.
 There should not be any broken braided
wire, knots or reduced diameter on the steel
wire line.
 Do not stride two feet to stand on the tow
wire or the steel wire line.
 When connecting the machine that needs
towed, do not stand between the machine
being towed and the towing machine.
 To make sure the hook is in the correct
position, the hook of the towed machine should
be in line with the towing part of the machine,.
Maintenance Precautions
Before Maintenance
Attention: If maintenance that is not
instructed in this “Operation and Maintenance
Manual” is done, unexpected failure may arise.
Please contact the dealers appointed by
Shandong Machinery CO., Ltd for service.
Warning Label
 If somebody starts the engine or shifts
gears during fueling or maintenance, serious
injury or death may arise.
 Glue the warning label on the shift levers
in the cab to remind people that you are