Instruction Manual

Caterpillar: Non-Confidential
height of the two sides should be the same.
 Make sure the surface of the tilted-plate is
clean, no lube, oil, ice or loose material. Clear
up the contamination on the machine tires.
 Do not turn the direction off the ramp. If
necessary, the machine should move away
from the ramp, adjust the machine direction
and then run up on the ramp.
 After the wheel loader is loaded on the
trailer, wedge the tire and tie and tighten the
machine with a cord.
Delivery
 When using the tow truck to deliver the
machine, the operator should obey by the
regulation for the weight, width, length and the
national and regional laws.
 When confirming the delivery route, the
operator should consider of the machine’s
weight, height, width and length.
 When passing over bridges or structures
on private land, check first that the structure is
strong enough to support the mass of the
machine. When the tow truck is running on the
road, the delivery must meet the requirement
of the related regulations and obey by them.
 When delivering the machine, the machine
might be divided into several parts. So please
contact the Caterpillar (Qingzhou) Ltd. dealer
to conduct this work
Battery and Maintenance
Danger Precaution
 The electrolyte of battery contains vitriol
and the battery can produce the hydrogen. So
the wrong battery treatment can cause the
serious injury or fire. Therefore, do follow the
following attentions. Never make the lightened
cigarette or fire close to the battery.
 Wear the safe glasses or rubber gloves
when you need to touch the battery during
work.
 If the electrolyte of battery spatters onto
the clothes or skin, please wash and clean with
water immediately.
 The electrolyte of the battery spatters into
one’s eyes, it may result in loss of sight. If the
electrolyte spatters into the eyes, please clean
the eyes with a lot of water to wash and see a
doctor immediately. Attention: If electrolyte is
swallowed inadvertently, drink large quantities
of water, milk, beaten eggs or vegetable oil.
Call a doctor immediately.
 Stop the engine before working with the
engine.
 Avoid contacting with the metal that may
cause a short circuit between positive terminal
(+) and negative terminal (-).
 First connect the positive terminal (+)
when assembling the battery. First disconnect
the negative (-) terminal (on the side of ground
cable) when disassembling the battery.
 First check which one is positive terminal
(+) or negative terminal (-) when
disassembling or assembling the battery. And
tighten the nut.
 Wipe with the cloth when cleaning the top
of the battery. Never use the gas, solvent, any
other organic solvent or cleanser. Tighten the
cover of battery.
 If the battery electrolyte is frozen, do not
charge the battery or start the engine with a
different power source. There is danger that
this will ignite the battery. When charging or
starting the engine with a different power
source, melt the battery electrolyte and check
for leakage of battery electrolyte before
starting.
 Disassemble the battery from the machine
before charging.
Jump-Starting the Battery
If the connection method of boosting cable is
wrong, fire might be caused. Jump-start the
machine according to the following method:
 Two operators are necessary when
starting (one operator should sit down at the
operator’s seat.)
 Do not allow the 2 machines to touch when
starting another machine.
 Turn off the two starting switches of
normal machine and failed machine when
connecting the boosting cable.
 First connect positive (+) cable when
setting boosting cable. First disconnect the
ground cable or negative cable (-).
 The last ground cable should be
connected to the engine cylinder of the failed
machine. However, this may cause fire. So