Instruction Manual

12
Caterpillar: Non-Confidential
in order to prevent dirt from accumulating on
the accelerator pedal and break pedal, and to
prevent pedal replacement
 Check the coolant level, fuel level, and oil
level in the engine oil pan, clogging of the air
cleaner, and damage to the electric wiring.
 Adjust the operator’s seat to a position
where it is easy to carry out operations, and
check for wear or damage to the seat belt and
mounting equipment. Change the seat belt
after three years.
 Check that the gauges work properly, and
check that the control levers are at the PARK
position.
 Remove all dirt from the surface of the
window glass and lights to ensure good
visibility.
 Adjust the side mirror to a position, which
gives the best view from the operator’s seat,
and clean the surface of the mirror. And clean
the surface of the mirror. If the mirror glass is
damaged, replace with a new part.
 Check that the front lamps and working
lamps light up properly. If the results of the
inspection show any abnormality, carry out the
necessary repairs.
 Be sure a fire extinguisher is present and
check the method of using it.
 Do not operate the machine near any fire
or flame.
When Starting Engine
 Walk around your machine and check for
people and objects that might be in the way
just before getting on.
 If a warning label, such as “DO NOT
OPERATE”, has been attached to control lever,
DO NOT start the engine.
 When starting the engine, sound the horn
as an alert.
 Start and operate the machine only while
sitting in the operator seat.
 Only the operator is allowed in the cab. Do
not allow anyone to ride on the machine body.
 Start the engine in the cab; never start the
machine by creating a short circuit of the
electromotor, this may damage the electro
circuit, and it is very dangerous.
 If there is a backup alarm, please check
that it works properly.
After Starting Engine Check-list
Failure to carry out the checks properly after
starting the engine will lead to delays in
discovery of abnormalities. And, this may lead
to serious injury or damage to the machine.
When checking the area one must ensure that
there are no obstacles and do not allow people
to come near the operation area.
 Check the functionality of the gauges,
work tools, and hydraulic system, brake
system, travel system and lubricating system.
 Check for any abnormalities in the sound
of the machine, vibration, heat, or smell; also
check that there is no leakage of air, oil or fuel.
 If any abnormalities are found, carry out
repairs immediately. If the machine is used
when it is not in proper condition, it may lead to
serious injury or damage to the machine.
 Before traveling or starting operations,
check that safety bar is securely placed in the
“unlocked” position.
Operation
Precautions When Starting Off
 Before starting off, check again that there
is no one in the surrounding area and that
there are no obstacles.
 When starting off, sound the horn as an
alert.
 Operate the machine only when seated in
the operator’s seat.
 Always fasten the seat belt. (If equipped)
 Only the operator is allowed in the cab. Do
not allow anyone ride on the machine body.
 If there is a backup alarm, please check
that it works properly.
Precautions When Traveling
 When traveling, never turn the key/start
switch to the off position. It is dangerous if the
engine stops when the machine is traveling
because the steering becomes heavy. If the
engine stops, apply the brake immediately to
stop the machine.
 It is dangerous to look around when
operating. Always concentrate on the work.
 It is dangerous to drive too fast, to
start/stop suddenly, turn sharply, or zigzag.
 If you find an abnormality in the machine