Specifications

AUDIO DET:ON YES/NO YES

YES

AUDIO DET:ON YES/NO NO

AUDIO DET:CON YES/NO YES/NO

YES

When this function is set to OFF

Self-Guard is programmed to record audio when Self-Guard detects motion from the

camera and audio from the microphone at the same time. Accordingly, even if there is

audio, Self-Guard goes into sleep mode and does not record audio when there is no

motion detected for selected time (1-9 sec., default 5 sec.) after the very last motion

detection. Self-Guard comes out of the sleep mode every 2 seconds to check if there is

a motion, and if it detects motion and audio, then it records audio. However, it does not

record audio when there is audio if there is no motion. This will result in discontinuance

audio sound during playback. Despite of the audio discontinuance, it is a very useful

function to extend the battery life for recording when Self-Guard is placed in a very loud

place.

When this function is set to ON

Self-Guard is programmed to record audio as soon as it detects an audio even if there

is no motion. When there is no motion or an audio, Self-Guard goes into sleep mode,

and check if there is a motion every 2 seconds. Self-Guard comes out of sleep mode

as soon as it detects audio sound even when it is in the sleep mode. In this mode, Self-

Guard is programmed to record with any audio detection, so you should be careful in

turning this function to ON in a loud place to prevent from wasting the battery.

When this function is set to CON

Self-Guard is programmed to record constantly regardless of audio or motion detection.

In this mode, battery gets consumed very fast requiring your attention.

You are recommended to use this mode only when you need to record very small

audio sound under the possible level of audio detection

4-8-2-8. DET. LEVEL: 1

Select audio detection level from 1 to 26. Lower the level for this function, it will detect

smaller sound. If you want to set the unit to record on loud audio detection, increase

the level to large numbers. If you set this level to a low value in a place with loud noise,

then Self-Guard will detect the noise as audio and thus record this noise. Test before

setting this level to avoid detecting and recording of noise.