Specifications

9
then you must exit from “RECORD” or “SEARCH” mode, before removing the
memory card from the Self-Guard.
 AUTO (POWER) OFF Function
The Self-Guard automatically turns off the power or goes into the power-
savings mode if you don’t press any button for a certain amount of time (1-9
minutes). This does not indicate malfunction of the system.
In “RECORD” and “TRANSMIT” modes, Self-Guard turns off only the LCD,
battery status LAMP, and recording status LAMP to save the battery. But, in
the rest of the modes except for “RECORD” or “TRANSMIT”, it turns off the
power completely. Set the time to 0 to deactivate “AUTO (POWER) OFF”
function.
Caution: To maximize the life of the battery, do not turn off “AUTO
(POWER) OFF” function.
 Discontinuance of audio sound during playback
You may encounter discontinuance of audio sound when you playback files.
This does not mean a product defect. Self-Guard is designed and set for the
power saving mode to intend longer battery life. Self-Guard goes into sleep
mode and does not record when there is no motion detected for selected time
(1-9 sec., default 5 sec.) after the very last motion detection. Self-Guard
comes out of the sleep mode every 2 seconds to check if there is a motion,
and if it does not detect a motion, then it repeats of going into sleep mode and
checking any motions in every two seconds. However, it does not record
audio when there is audio if there is no motion. This will result in
discontinuance audio sound during playback. Self-Guard can be programmed
to go into sleep mode even when there is audio sound but without a motion,
and this causes audio discontinuance during playback. If you want to record
audio sound without disruption, then you should turn ON audio detection
function from “Power Set”. For detailed information on this, refer to 4-9-3-7.
AUDIO DET: OFF
 Operating conditions