Specifications

If you set the Self-Guard to the “TRANSMIT” mode, then you can access the image

and voice of the Self-Guard currently being recorded using a computer by LAN in the

remote places. Also, you can copy the data in the Self-Guard to your remote computer.

Using the Bluetooth (SG-3000 only), you can wirelessly access or copy the image and

voice of other Self-Guards with a Self-Guard from a remote place. You need to know

the Self-Guard’s ID and the Password in order to connect to the Self-Guard by LAN

with a computer. And when you want to connect a Self-Guard with other Self-Guards,

you need to know the Bluetooth ID of the Self-Guard that you want to access the data

of.

In “TRANSMIT” mode, even if the Self-Guard was cut from the power resources

(battery or the adaptor), it automatically turns on itself, and returns to “TRANSMIT”

mode as the Self-Guard gets provided with the power resources again. This function is

very useful when you set the Self-Guard in a remote place from where you are, and

cannot control over it immediately. All the functions in “TRANSMIT” are the same as in

“1.RECORD”, except that the Self-Guard does not record data in “TRANSMIT” mode.

6. BLUETOOTH (SG-3000 only)

When using the Bluetooth, you can get faster image transmitting speed by setting the

image compress resolution to 128x128 for the slave Self-Guards. The transmitting

speed goes down as you increase the image compress resolution and set it higher than

128x128. It is recommended to set the image compress resolution to 128x128 when

using the Bluetooth.