Specifications

The resolution of the current data appears on the lower left side of the magnified

screen, and the magnification ratio appears on the lower right side of the LCD screen.

In the magnification mode, you can move to the left, right, up, and down direction by

using the direction buttons, and press [ENT] to change the magnification ratios, and the

ratios repeat x 1 → x 4 →x 16 as you press [ENT] continuously.

In 480x480 and 640x480 pixels of resolutions, it is possible to magnify the images up to

16 times (width x 4 and length x 4), and the magnifying order is x 1→ x 4 → x 16. But,

in 240x240 and 320x240 resolutions, you can magnify the images by 4 times only

(width x 2 and length x 2), and the magnifying order is x 1 → x 4. You cannot magnify

the images in 128x128 and 160x128 resolutions. To escape from the magnification

mode, press [ESC].

3-2. SENSOR

Using the direction buttons, select “2.SENSOR”, and press [ENT]. Then, you can

search the data saved by the sensor detection only. The searching method is the same

with “1.MOTION/SENSOR”. But the only difference is that in “1.MOTION/SENSOR”,

you can search the data created both by the motion detection of the image and sensor

detection, whereas in “2.SENSOR”, you can search the data created by the sensor

detection only. When you want to search the data saved only by the sensor detection,

then this function is useful for the faster search than you can with “1.MOTION/

SENSOR”.