Data Sheet

www.self-ecg.com
Last update: 29 June, 2017
Page: 2 of 5
In
Input
Other
Note
Note
Ambient
and Life
Protection
Output
Model
Specifications
Specifications：
turn on time(S)
turn on time(S)
output power(W)
output power(W)
output votage(V)
output votage(V)
output voltage tolerance
output voltage tolerance
ripple voltage(mV)
ripple voltage(mV)
working current range(A)
working current range(A)
dimming interface
dimming interface
dimming range
dimming range
rated supply voltage(Vac)
rated supply voltage(Vac)
voltage range(Vac)
voltage range(Vac)
line frequency(Hz)
line frequency(Hz)
input current(mA)
input current(mA)
efficiency
efficiency
average efficiency
average efficiency
no load power consumption(W)
no load power consumption(W)
power factor
power factor
inrush current(Ipk)
inrush current(Ipk)
over voltage protection
over voltage protection
short circuit protection
short circuit protection
over temperature protection
over temperature protection
automatic restart
automatic restart
over load protection
over load protection
surge capacity
surge capacity
Ta(
Ta(℃
)
)
Tc max.(
Tc max.(℃
)
)
Storage Temperature(
Storage Temperature(℃
)
)
ambient humidity range
ambient humidity range
nominal life-time(hrs)
nominal life-time(hrs)
weight(g)
weight(g)
dimensions (L×W×H)(mm)
dimensions (L×W×H)(mm)
casing material
casing material
housing colour
housing colour
type of protection
type of protection
protection class
protection class
216
50000@Tc:85
298×29.8×16.5
Plastic
Grey+Blue
IP20
Class2
1. Tolerance:includes set up tolerance, line regulation and load regulation.
2. Tested at full load,230Vac.Refer to"Power Factor" and "EFFICIENT"curve graphs.
3. Calculate the model’s average efficiency for each test voltage by testing at 100%, 75%, 50%, and 25% of
rated current and then computing the simple arithmetic erage of these four values.
4. All parameters NOT specially mentioned are measured at nominal voltage input, rated load and 25 of
ambient temperature.
5. The power supply is considered as a component that will be operated in combination with final equipment.
Since EMC performance will be affected by the complete installation, the final equipment manufacturers must
re-qualify EMC Directive on the complete installation again.
216
-30...80
5%...85%，Not condensing
-20…45
90
-20…45
90
YES
YES
YES
YES
YES
L-N:1kV
YES
YES
YES
YES
YES
L-N:1kV
220-240
198-264
50/60
600
91.5%
89%
＜0.3
0.95
35.8A/92.5uS
120-240
108-264
50/60
600@230V,800@120V
92.3%
90%
＜0.3
0.95
38.2A/92.5uS
＜0.5
96
12
+/-5%
800(Vp-p)
0-8.33A
＜0.5
100
24
+/-5%
800(Vp-p)
0-4.17@230V
0-3.33@120V
No
n/a
2
2
1
3
SLT100-12VFG
SLT100-12VFG
SLT100-24VFG-UN
SLT100-24VFG-UN
50000@Tc:90