User's Manual

Model 1150A DVOR
3-64 Rev. - November, 2008
This document contains proprietary information and such information may not be disclosed
to others for any purposes without written permission from SELEX Sistemi Integrati Inc.
Figure 3-61 LCU Transmitter Temperature Readings
Table 3-5 Equipment Control Panel Functions (Refer to Figure 3-62)
TRANSMITTER
(Refer to Figure 3-54)
Note: Switches are active in Local Mode only.
Main Select 1 and Indicator
Pressing Main Select 1 switch sets transmitter 1 as the
main transmitter and places TX1 on the antenna and in
the ON mode. The indicator in the switch illuminates to
identify that TX 1 is selected as the Main.
Main Select 2 and Indicator
Pressing Main Select 2 switch sets transmitter 2 as the
main transmitter and places TX2 on the antenna and in
the ON mode. The indicator in the switch illuminates to
identify that TX 2 is selected as the Main.
Antenna 1 and Indicator
Pressing Antenna 1 switch turns transmitter 1 ON and
into the antenna. The indicator in the switch illuminates
to identify the transmitter connected to the antenna.
Antenna 2 and Indicator
Pressing Antenna 2 switch turns transmitter 2 ON and
into the antenna. The indicator in the switch illuminates
to identify the transmitter connected to the antenna.
Load 1 and Indicator
Pressing Load 1 switch turns transmitter 1 ON and into
the load. The indicator in the switch illuminates to
identify the transmitter connected to the load.
Load 2 and Indicator
Pressing Load 2 switch turns transmitter 2 ON and into
the load. The indicator in the switch illuminates to
identify the transmitter connected to the load.
Off 1 and Indicator
Pressing Off 1 switch places transmitter 1 in the OFF
mode without changing the relays. The indicator in the
switch illuminates when the transmitter is OFF.
Off 2 and Indicator
Pressing Off 2 switch places transmitter 2 in the OFF
mode without changing the relays. The indicator in the
switch illuminates when the transmitter is OFF.