User's Manual

Model 1150A DVOR
3-50 Rev. - November, 2008
This document contains proprietary information and such information may not be disclosed
to others for any purposes without written permission from SELEX Sistemi Integrati Inc.
3.6.8.2.5 Monitor Test Signal Output Control
The Monitor Test Signal Output Control is shown in Figure 3-45. This screen is used to connect the desired signal to
the Test BNC connector (J3) on the front of the Monitor circuit card assembly for maintenance purpose. Each of the
signals are available to be connected to test equipment. The default signal connected to the Test connector is the
Integral composite. Selection of these signals has no effect on the Monitoring performance.
Figure 3-45 Monitor Test Signal Selection