User's Manual

Model 1150A DVOR
3-30 Rev. - November, 2008
This document contains proprietary information and such information may not be disclosed
to others for any purposes without written permission from SELEX Sistemi Integrati Inc.
3.6.7.4.5 Security Codes Configuration Screen
The Security Codes screen is shown in Figure 3-25. This screen is used to configure the security access credentials
for each user, including User ID, Password, and Security Level. This User ID/Password information is encrypted
and stored in the non-volatile RAM (NVRAM) on the RMS CCA. This screen is only available to the Level 4 user.
Figure 3-25 Security Codes Configuration Screen
3.6.7.4.5.1
User Account Maintenance
As part of initial configuration, several user accounts should be setup, corresponding to the access levels required.
User account maintenance can only be done through a direct connection (i.e. not via a remote modem) in the
LOCAL mode, from within Security Level 4, with the exception of changing the current user’s password. All users
can change their own passwords, when connected directly and the system is in Local Mode, through the RMS >>
Commands >> Change Password menu option. Refer to Figure 3-25 for the Security Codes Configuration Screen.
3.6.7.4.5.2
Add a User Account
1. Log on to Security Level 4 and select the RMS >> Configuration >> Security Codes screen.
2. Click on any empty User ID field.
3. Enter the desired User ID. Note that the User ID must be 4 to 32 characters in length, is case-sensitive, and
can contain any alphanumeric characters.
4. Press TAB to move to the associated Password field.
5. Enter the desired Password. Asterisks will hide the password on the display. Note that the password must
be 4 to 32 characters in length, is case-sensitive, and can contain any alphanumeric characters.
6. Select the desired Security Level for this user.
7. Repeat these steps for any additional users.