User's Manual

MODEL 2130 MARKER BEACON
8-4 Rev. A April, 2005
This document contains proprietary information and such information may not be disclosed to others for any
purposes without written permission from SELEX Sistemi Integrati Inc.
8.5.2 Installation Kits
Refer to the following tables for kits required to install a Marker Beacon station.
Table 8-1 Marker Beacon Installation Kits
Part No. Description
950331-0000 Shelter, 6' x 8', federal
950281-0000 Shelter, 6' x 8', non-federal
470597-0001 Marker Beacon Installation Kit
Refer to Figure 11-9 for illustration and parts list.
470595-0001 Battery Backup Installation Kit
Refer to Figure 8-3 and 11-7 for illustration.
470592-0001 Single Yagi Transmitting Antenna and Tower Installation Kit
Refer to Table 7-9 for parts list.
Refer to Figure 11-4 for illustration and parts list.
470596-0001 Single Yagi Transmitting Antenna and Pole Mount Installation Kit
Refer to Table 7-10 for parts list.
Refer to Figure 11-8 for illustration and parts list.
8.5.3 Shelter Installation
Refer to a list of materials included in the Shelter Installation Kit (470240-0001).
a. See Figure 8-1. Using a crane and four nylon slings (20 feet long), position the equipment shelter (950281-0000 or
950331-0000) on the four concrete piers.
b. Attach the shelter to the pier anchor bolts using the 5/8-inch hardware, beveled washers, and tie-down plates.
c. Install shelter and antenna tower ground rods (900076-0000) and connect with No. 6 AWG bare copper wire (146006-
0000) as shown in Figure 8-1.
d. Connect main AC power to the shelter circuit breaker panel.
8.5.4 Marker Beacon Transmitter Cabinet Installation
Figure 11-9 gives the list of materials and installation details for the Marker Beacon Installation Kit (470597-0001).
a. Install Marker Beacon cabinet per Figure 11-9.
b. Install AC power to Marker Beacon cabinet. For wiring details, see interconnect diagram, Figure 11-11.