Specifications

LD600-12 Manual Selectronic Australia

Maintenance

Inverter

Periodic maintenance of your LD600-12 inverter involves little more than

checking for any obstructions to the black cooling heatsink at the rear of the

inverter. The heatsink must be cleared of any accumulated foreign matter that

may have lodged itself between the fins since the last maintenance check, e.g.

insect nests. Also verify that airflow around the inverter has not become

restricted.

Batteries

1. Every week, carry out a thorough visual inspection of all battery

wiring, taking particular note of the condition of inter-connections

between cells. This maintenance should be carried out in conjunction

with the battery manufacturers recommended maintenance.

Safety Hint

When working on batteries of such high capacity it is

essential that you wear protective clothing, some form of eye

protection and rubber-soled work boots. Please regard your

batteries with a great deal of caution, and if in any doubt,

entrust this work to your supplier / installer.

2. Check that the stainless steel inter-connecting bolts are tight and have

no corrosion. If corrosion is evident, carefully follow the following

procedure.

 Disconnect the system battery fuse before working on the battery

bank.

 Unbolt the stainless steel bolts and nuts of any corroded

connections and thoroughly clean the joint with a wire brush or

file, taking extreme care not to short circuit any battery cells with

any tools.

 Re-assemble and smear a small amount of Vaseline or similar

grease over the surface of the joint to slow down any future

corrosion.