Datasheet

ESG
8.458.45
8.458.45
8.45
15,5
6,5
min. 90 10 2
For mounting, put
unprinted side on the
heat sink.
Remark:
The very small case of the thermo switch and the direct mounting on
the heat sink guarantees a fast reaction on temperature changes.
If the thermo switch is connected in series with the drive voltage of
the SSR, it disconnects the drive as soon as the admissible operation
temperature is exceeded. The drive will only be released, when the
operation temperature reaches the correct value again.
Alternatively the thermo switch on the three-phase load relay can
also be connected on two free terminals B1 and B2 to allow an over-
temperature message via an alarm light or a relay.
Be careful in using motors, as such units can again be switched
on automatically when the temperature drops.
Only to use with the HRL construction.
Description Type Weight Article no.
Thermo switch 70 °C TS 70 - 41920014
Thermo switch 90 °C TS 90 - 41920016
(Order data see chapter 1)
Accessories
Thermo switch for 3-phases solid-state relays