Instruction Manual

92-300110-18 (08/2018)
2” Cordless
Fauxwood Blind Installation Instructions
Step 5: Valance Installation
Step 1. Attach the loose plastic Valance Clips to the front of the headrail, one at each end. Space any remaining clips evenly. Press the slot in the
Valance against the bottom post of the Valance Clip and rotate it upwards.
Step 2. Push the Valance against the Valance Clip. The two parts should snap together.
Step 6: Blind Installation
Align the headrail with the center support and box brackets. The headrail
should have the tilt mechanism facing toward the room. Be careful not to
trap the top slat in the brackets and slide the headrail straight back until
it is snug in the brackets. If the headrail can slide from side to side in the
box brackets, you can use a flat head screwdriver to bend out the tabs on
the end of the until it is snug.
Lower the front gate of each box bracket and press until the locking tab
clicks into place.
Operating Instructions:
To lower the blind, pull down on the bottom rail with one hand gripping it near the middle or with both hands grabbing the bottom rail at the equal
distance from the center. When released shade will stay in place at desired height. To raise the blind, push up on the bottom rail near the center to reach
desire height. Once released, shade will stay in place.
To tilt the blind, turn the tilter wand in either direction.
Valance Clips Needed
Up to 47.99” 48” - 71.99” 72” - 95.99” 96” - 119.99” 120” +
2 3 4 5 6
For your convenience, extra valance clips are included.