Owner's Manual

Snap side panel back
in place.
Replace glove box the
same way you removed
it, making sure your wire
harness isn’t in the way.
14
15
Push larger speaker terminal
of Pillar-Pod connectors through
grommet first, then the smaller.
(Tight fit to minimize air escaping).
Remove poly-fill from pods for the moment.
Run speaker terminals through small hole in
back of each pod and seat grommet in hole
by pushing it in and picking it through with
your other hand.
Replace the poly-fill, spreading it out
inside the pods, making sure the wires
are hanging out. Connect terminals to
speaker. Large terminal is pos.+ and
small terminal is neg.-
Find the pod’s sweet spot. You’ll find the
pods kind of lift and slide up the Jeep pillar
slightly to find the correct position. Hold
pod in place with one hand and run the upper
self-tapping screw through the pod and
into the plastic pillar piece until just snug.
Run the lower screw in next.
16
17
18
19
20
21
Good approx. locations for self-tap
screws shown by white dots inside
pod. May help to pre-drill but not
absolutely necessary. If you do, be
sure to remove any plastic shavings
on the other side from drilling through
so you get a nice fit on the plastic
windshield piece on the Jeep.
2015-2018 Wranglers:
Leave enough wire coming out in the
shown area and snap tweeter covers
back in place. Put pod in place and pull
all excess wire through. The idea is to
have enough wire to hold the speaker
up and connect to it easily once pod
is affixed to vehicle. Excess wire goes
below in tweeter cavity.
Situate speakers and grilles with logos
how you like and screw speakers in
place with the screws that came with
your speakers. Most of the time the
screws will grab and make their way
through the plastic. You can pre-drill
some holes with a small drill bit if needed.