Owner's Manual

Use a mini plastic pry bar or thin flathead screwdriver and
pop of Driver side dash side panel as shown. It’s held on by
several plastic clips and will simply snap back in place later on.
1
2
Pop off Passenger
side panel in same
manner.
Pop off tweeter covers with
plastic mini pry bar or thin
flathead screwdriver.
Remove two bolts for each
tweeter with 7mm socket
and ratchet.
If you have 2015-2018 Wrangler, remove factory tweeters as seen in these images.
If you were to look up under the dash
on the Driver side, you’d see the back
of the factory speaker enclosure and
this gray plug on the back of it.
3
Reach up and disconnect
it (one half will stay
mounted to the enclosure).
Take one of the wire harnesses that came with your pods
and reach up and connect the proper piece to the back
of the factory enclosure, and the other to the now
dangling factory plug you disconnected.
4
Disconnect and remove factory tweeters. The plugs can drop
down in the cavity, you won’t use them for this install type.
If one of those wires (Driver side) has a purple stripe, you
have a “standard” system and must follow Installation #2 and
need one of those wire harnesses instead. You needed Pillar-
Pods part #PP1518 or #PP1518-K (with Kicker speakers) to
get the correct harness.
Driver side will look like below. If you have a later model with the factory amplifier
located behind the Driver-Side factory speaker enclosure, you can still see the plug and
do it as shown below, but see the next page on how to quickly remove a couple things
if you’re having trouble reaching the plug.
Installation type #3 continued