Owner's Manual

Installation type #3: 2007-2018 models with Infinity®
or Alpine® systems equipped with a factory subwoofer
in the cargo area. In some cases, only Driver side
images are shown, simply repeat process for the
passenger side.
Pop off tweeters with plastic
mini pry bar or thin flathead
screwdriver.
If you have a 2007-2014 Wrangler, remove factory tweeters as seen in these images.
Disconnect and remove factory tweeters. The plugs can drop down in the cavity, you won’t use them for this
install type. If one of those wires (Driver side) has a purple stripe, you have a “standard” system and must
follow Installation #1 and need one of those wire harnesses instead. You needed Pillar-Pods part #PP0714 or
#PP0714-K (with Kicker speakers) to get the correct harness.
Connect pods to factory tweeter
connectors. They’ll clip together.
Put white plastic connectors below
tweeter covers leaving as much wire
as possible coming out in the shown
area and snap tweeter covers back
in place. Put pod in place and pull
all excess wire through.
Replace the poly-fill, spreading it out
inside the pods, making sure the wires
are hanging out. Connect terminals to
speakers. Large terminal is pos.+ and
small terminal is neg.- There’s not much
spare wire, but there’s enough to
make the connections.
Find the pods’ sweet spot. You’ll find
the pods kind of lift and slide up the Jeep
pillar slightly to find the correct position.
Hold pod in place with one hand and run
the upper self-tapping screw through the
pod and into the plastic pillar piece until
just snug. Run the lower screw in next.
10
11
9
7
8
Situate speakers and grilles with logos
how you like and screw speakers in
place with the screws that came with
your speakers. Most of the time the
screws will grab and make their way
through the plastic. You can pre-drill
some holes with a small drill bit if needed.