Owner's Manual

11
Run Power Wire under carpet in passenger foot area
and feed it under center of dash on top of metal hump
until it exits over in the driver foot area. Leave it there
for now and let’s move on to the amp’s Remote Wire.
13
For ’11-’16, pop out window switch panel with a good tug
and unplug it. Then remove the single screw (arrow).
This allows you to pop off the top piece of the dash a little
(the piece with the vents) so you can pop off the lower AC
Control piece that has the cigarette lighter outlet. It is
piggy-backed to the top vent piece with plastic mounts at
the red circles and you need to slide it off them. Then you
can reach behind and unplug everything to gain better
access to the outlet wiring. Next follow # 14.
Next step is the amplifier Remote Wire.
2007-2010 models see #12. 2011-2016
models see #13.
12
‘07-’10, pop out the cigarette lighter housing
on the left
using a small pick or tiny flathead- the tabs
right behind the face can be pushed in to pop it out.
(Easier than removing the whole dash piece).
This is the switched port you want to use and
the blue wire with pink stripe is the wire you want
to splice into for the Remote amp wire. You can feed
the wire down behind the panel and into the driver
foot area, under the carpet. Note: if you’re adding other
amplifier(s) for other audio upgrades, you only need to run
this single Remote wire over to the amp(s) and can then
splice into it for additional short runs to the other amp(s).
Next follow #14, then #16 for the rest of your ‘07-’10 install.
14
Tap into the blue wire with pink stripe. The
Black/White Stripe wire is the Ground and remains
as-is. Note: if you’re adding other amplifier(s) for other
audio upgrades, you only need to run this single
Remote wire over to the amp(s) and can then splice
into it for additional short runs to the other amp(s).