Owner's Manual

5
Now run the wires over to where the amplifier will be
installed under the driver seat. If using your own amp, it
will have either a High Level Input with a small plug of wires,
or a High/Low Level button the wires will connect to using
RCA adapters. Consult the manual for your amp.
*If you purchased the pods with the Kicker amplifier, specific
RCA connectors are included. Make note of which wires are left,
right, pos.+ and neg.- wiring them as indicated on the RCA
housings, and you must have the button on the Kicker
amplifier set for High Level input.
Amplifier Ground: An easy connection is already right
under the Driver seat. It’s up by the inner seat bracket
on the uphill slope of the floor. Use 10mm wrench to
loosen the nut and use a ring terminal on the ground
wire. Ground Wire must be connected to amp prior to
attaching Power or Remote Wires to amp!
6
Amp Power Wire: Pop off this little side panel on
the passenger side dash with a flathead screwdriver.
It pops off easily. (This is the panel in later models).
7
8
Behind it is a little hole that has foam in it. Use a
piece of wire such as a coat hanger with the power
wire taped to it and poke it through.
9
Power wire will pop through here. Note: if you’re
adding other amplifier(s) for other audio upgrades
you should run separate Power wires for them.
Fuse holder can be mounted by battery as shown.
Don’t connect the power wire unless amp
ground wire is already connected so amp is grounded!
10