Owner's Manual

HOW TO WIRE IN YOUR NEW JKU-PODS
These instructions are of installing the #30647KL version of the JKU-Pods (Kicker amplifier included) in a factory sound
system with the basic 130 Radio. Some connectors and hardware shown are included only with this version.
These instructions describe wiring paths with the amplifier located under the Driver Seat
.
You must run two sets of speaker wires from the pods
to your amplifier. Make note of which are left, right
and pos.+ and neg. – so you know which is which up
at the amp. Start with the passenger side pod: unzip
the sport bar fabric to slip the wire underneath.
When it’s over by the driver side pod, start a second
run of wire for the driver side pod and bring both
pairs together down the sport bar as shown here.
2
1
Pulling the carpet back, you can grab the wires as
they’re fed under the plastic piece at the base of
the sport bar.
Continue running the speaker wires under the
carpet along the driver side wheel well. Bring
them under the rear floor carpet until you get
under the driver seat. They can exit at seat
bracket or you can make a slit in carpet at the
exact spot where they’ll connect to the amp.
3
If you don’t have an aftermarket radio and are tapping into
the factory sound bars’ speaker wires for signal, do it here by
the passenger seat. The wires are under the plastic trim. Pop
out the two plastic rivets and remove some of the electrical
tape. Your wires will go under the carpet . Follow the wire
color code below, making sure to mark which is which for the
amp.
If purchased version with Kicker amplifier included, you have
these blue lock wire connectors (shown).
4
Gray with Light Green Stripe is Left Rear (+) Dark Green with Light Green Stripe is Right Rear (+)
Gray with Dark Green Stripe is Left Rear (-) Dark Green with Gray Stripe is Right Rear (-)
*If you purchased #30647KL with Kicker amplifier included and are installing the pods in a factory
stereo system, use the 20’ length of speaker wire included in the amp wire kit
to tap into the factory speaker
wires described in #4, and use the other 25’ speaker wire length included in your #30647KL kit for #1-3.