Owner's Manual

The screw recess areas are a tight fit not just for a nice

look, but for rigidity since they’re the mounting points

and flex in the plastic should be minimized. So, if a

screw went in a little off-center and you’re having

trouble popping the screw cap over the head, no

worries. The caps are thick plastic and you can easily

remove some with a rotary tool or even shave some

excess off carefully with a razor blade until the cap can

clear the pods’ recess and pop on the screw head.

We also make the Stealth-Pod for Wrangler JKU’s like yours:

It holds a 10” subwoofer and suspends on the tailgate. It’s also portable.

www.jeepsound.com

p.6

Repeat process for passenger side pod. Hint: when affixing the pod,

make sure it’s at the same pitch as the driver side pod for best appearance.

This screw

next.

Generally under tweeter area, push pod up to

remove any play in the foam underneath. The

screw is roughly perpendicular to the fabric and

pre-drilled hole acts as guide for proper direction.

Hold the pod firmly in place: the screw will

puncture the fabric, quickly spin through the foam

and hit metal. Hold everything steady throughout

this process allowing the screw to drill through

metal. Once you’re through, the pod will cinch

down nicely against the fabric within a few

revolutions.