Owner's Manual

Insert your rubber grommet. This is where the

wires will exit the pod.

While it’s better to remove the excess, if you’d rather not cut and

solder the wires shorter, you can use a long zip tie as shown and wrap

all the excess wire length, holding in place on top of the crossover.

Just be sure it’s tight and secure so there’s no rattling later. Leave a

little ‘Mid’ wire out so you can attach to the woofer. Pull the input

line through the grommet hole and out of the pod. Later, you’ll

connect it to the length of speaker wire that comes from your

amplifier (see wiring instructions pages).

And if you purchased the pods with the Kicker

component system included, they come with

correctly sized tape squares for the crossovers…

…so you can affix the crossovers inside the pod as

shown, leaving enough ‘Mid’ wire out to connect to

the woofer.

If installing crossovers inside pods:

Re-install the poly-fill and connect the ‘Mid’

wires to the woofer.

Woofer installation:

Affix the woofer with the logo oriented in same manner

as the tweeter logo for the best appearance.

p.4