Owner's Manual

‘11-’16 Feed remote wire down behind dash to meet
up with power wire and run remote wire under dash
to driver side area just like power wire was done.
Note: if you’re adding other amplifier(s) for other
audio upgrades, you only need to run this single
Remote wire over to the amp(s) and can then splice
into it for additional short runs to the other amp(s).
15
Bring the Remote and Amp Power wires under the
carpet, between driver seat and center console so
they can come up from under the carpet under
the driver seat. You can bring them up where the
other factory wiring for the seat exits, or cut slits in the
carpet exactly where they will need to be for the amp.
16
A clean looking install of the Kicker amp under the driver
seat with only the speaker input leads showing. Easy
access to amp’s controls from here, and all other
wires are on other side of amp and hidden from view.
For Kicker amp, this is how we ended up setting ours:
Stock 130 radio in our Jeep so input level is on High and
we tapped into the sound bar speakers. We put the
gain about a third of the way up and kept the x-over
off so the pods get the full audio spectrum. We had
the bass boost down/off. We had our regular stock
130 radio set at +4 bass, +1 treble, +2 mid, balance
centered and fader at +4 Front. It’s at least a good
starting point for you if you got the Kicker amp too.