Owner's Manual

Place
the pod
in
cargo area passenger side
(we'
ll
fine tune exact positioning later) and
start to tuck speaker wire under carpet.
Pop
wires up through carpet at your amplifier (a
small slit
in
the carpet at the appropriate are
will do) and connect wires to amp.
Close tailgate. Note pencil in photo. The pod
installs quite close to the tailgate (in
TJ's)
and the
lower section where the subwoofer
is is
the point that
comes closest to the tailgate.
Photo is in a TJ.
Earlier
CJ7 and
YJ
Jeeps have a slightly larger cargo area so
the pod
won't
be as close to the tailgate as this.
Once
the pod is exactly where you want it, open the tailgate
to begin attaching pod to floor.
This screw
next. Note Intsa-trunk wall
in
photo. Drill extension would contact it, but
no need to remove the wall
if
you have one.
Pod
should be about
W'
to
5/8"
away from
passenger side wheel-well. (Note lnsta-Trunk
wall in photo -
if
you have one, make sure the
pod doesn't touch the wall or its assembly bolts).
Ideally, you'll want an extension for your drill like the one pictured
(left) to attach to your
3/8"
hex bit. Otherwise the drill chuck can hit
the pod (see arrow, right) when it spins and can mar the pod.
This screw first.
Hold pod firmly
in
place when
running screw
through carpet
and into floor.
This screw last. Then push
the black screw caps included
over top
of
each screw. Time
for sound tests and adjustments
of
your radio and amp settings.
(See first page).
5