Owner's Manual

PART 2 -
Sono-Pod Installation:
The Sono-Pod installs right over
your existing cargo footman loops
on your floor, no need to remove.
You
may have to
cut
the
subwoofer
hole
larger
to
accept
your
particular
sub;
easily done with a rotary cut-out tool and either
a spiral drill bit or even a sanding drum such as used with a Dremel® rotary tool. (The pre-cut hole is about 9" diameter so it can
work with subs that need smaller cutout diameters).
Install rubber grommet
in
underside hole and run
speaker wires through to connect to your subwoofer.
Place sub in pod and gently pull any excess speaker
wire back through the grommet. This may take a few
attempts
...
you want it slightly loose but excess wire
could vibrate
if
it's touching the pod walls.
Use a glue gun (or similar medium) to plug any
remaining air space around speaker wires as they
exit the grommet to ensure an air-tight seal (air
escaping could make a whistling noise on bass notes.
Use (8) provided black subwoofer screws
to affix sub to pod,
starting
with a drill w/
phillips bit.. ..
. .. but it's a good idea to
finish
tightening
>
by hand to avoid stripping the plastic
in
case
L---------
you have a pretty powerful drill.
©
4