Owner's Manual

Amplifier ground wire:
should be kept as short as possible and should be connected and grounded before ever
connecting the amp power and amp remote wire.
If
you send power to the
amp
without having the ground wire
connected
and
grounded, you could damage the amp!
Rear seat bolt is a good place to connect the
amp ground wire (see #6 on page 1).
Amplifier Power wire:
best place to break through to engine bay is the same spot on CJ7's,
YJ's and
TJ's
(see #5 on page 1). And try to keep this wire away from the RCA -related (signal)
wires-
the power wire
run alongside RCA or speaker wires can cause interference and compromise sound quality.
Amplifier Remote Wire:
You
want a 12v
switched
wire such as the pos.+ on a TJ cigarette lighter, or your
aftermarket head unit likely already has a remote wire you can tap into for this.
"Switched"
meaning
the wire
only has power when the Key is turned on in the ignition.
(If
you purchased the fully loaded #63092KL version,
use the
Sth
and final blue lock-wire connector for tapping into this 12v switched wire
if
using cig. lighter).
Speaker
wire from
Amp
to Sono-Pod:
Fully loaded #63092KL version
Sono-Pod
includes amp wire kit with
plent)
of
speaker wire for this. Run only one pos.+ and one neg.- from amp to
pod-
see Kicker amp sheet for more info.
Kicker
Remote Bass Level Controller:
(#63092KL fully loaded
Sono-Pod).
Just need to find a nice home for it
somewhere you like
on
your dash, console, etc. Somewhere it's easy to reach for because it's awesome and you'll
use it often!
+
battery
fuse
Ground
AMP
Select
Increments
4WDAUDIO
headunit
remote
Remote
Bass
Level
Controller
(fully
Sono
-P
od
#63092KL)
t
rca
leads
x2
or
possibly these
if
purchased #63092KL
and have factory radio or no pre-amp RCA
outputs on back
of
radio, see page 2)
t
www.selectincrements.com
Email: [e-mail]
610-345-9044
landline, no texts.
3