Owner's Manual

With seat all the way forward and the carpet in flat, factory positioning, angle pod in as shown, getting that “wing”
(with the Neo-Pod logo) around the right seat frame/leg. The pod then easily slides up in to position. If vehicle has no
carpet, you need to put some little pieces of carpet or foam, etc. under the rear legs and everywhere up front the pod
would normally rest on carpet to lift the pod to correct height - necessary for screws used to mount pod (screw length
and undercarriage) and to isolate the pod so there are no vibrations off the metal floor.
Leave the length of speaker wire over here for now.
Lifting the carpet to hide the wires now may leave some
weird rise or kink in the carpet where the sub fires.
Best to wait until the pod is screwed down and holding
the carpet in place much more.
Top of pod should be clear of any obstructions.
If your model JK has the two big looms of wires
shown right of the pod here, they can and will
touch the side of the pod similar to shown. You
should have full seat slider ability, all the way
forward, all the way back, without stressing wires.
Sides of pod should not be in contact with any brackets,
seat legs, etc. Rear pod legs should be centered between
seat legs, not touching anything.
Install: Part D
Attaching Neo-Pod to Jeep floor