Owner's Manual

Clearing a path for the Neo-Pod (to be done after completing Part A wiring installation sheet)
Different model Wranglers from different years will have different wiring and wire-plug configurations. The images below
will cover most scenarios and the goal is to situate any plugs and wires so they’re out of the way of the pod. You can do
this and install the pod without ever removing the seat! Always check for full seat slider movement as you work to ensure
wires aren’t stressed/tight at seat-sliding maximum positions.
The screws are Torx T30, but
if you don’t have a torx bit, they
remove pretty easily with a thin
flathead screwdriver.
‘11-’17 models likely have this bracket & plugs.
Pop off the plugs and remove the bracket.
The plugs can conveniently pop in existing holes on
the underside of the seat as shown.
Remove the non-ribbed tab with snips to get this plug
even further out of the way and for better staying power.
A cable tie can hold the excess wire lengths to
the spring work of the seat bottom, (check for
full seat slide ability front to back).
Heated Seats: wires can be moved
along the inside frame rail and
cable tie(s) can hold them out
of the way. Again, check for full
slider movement with no stress
on the wires. And they should not
come in contact with the pod
when it’s installed (to avoid any
vibration).
Install: Part B