Owner's Manual

Bring the Remote, Bass Level Controller, and Amp Power
wires under the carpet, between driver seat and center
console so they can come up from under the carpet
under the driver seat. The excess wire for the Bass
Controller can be wound up and placed as shown without
affecting the carpet. All wires can then come up where the
other factory wiring for the seat exits, or you can cut slits in
the carpet exactly where they will need to be for the amp.
10
For ’11-’17 Models (continued):
With Remote wire completed and controller in place,
you can re-attach all plugs and pop the dash panels back in
place, including the power-window panel. To feed the
wire for the controller, pop of the mesh panel piece shown
and push wire through until you can grab it over to the left
under the carpet. Then pop the panel back on, it can snap
back in place right over the wire just fine.
n
t
ALL MODELS
11
A look at the amplifier in its’ final resting place under
driver seat. (Easy access to the controls in this
configuration.) Tuning the Kicker amp & sub, we
found our settings ended up at a little more than
halfway up on the gain control, and the bass boost at
about two-thirds up. We left the Xover at 200. A good
place to start your tuning, if nothing else. When tuning,
try FM stations too… FM stations are being pulled in
versus CD or MP3 which are produced internally, so the
sound reproduction for FM stations typically is not as
good as CD and MP3. Including them in fine tuning will
help you decide on your settings.