Owner's Manual

Amp Power Wire: Pop off this little side panel on
the passenger side dash with a flathead screwdriver.
It pops off easily. (This is the panel in later models).
4
5
Behind it is a little hole that has foam in it. Use a
piece of wire such as a coat hanger with the power
wire taped to it and poke it through.
6
Power wire will pop through here. Note: if you’re
adding other amplifier(s) for other audio upgrades
you should run separate Power wires for them.
Fuse holder can be mounted by battery as shown.
Don’t connect the power wire to amp unless amp
ground wire is already connected so amp is grounded!
7
8
Run Power Wire under carpet in passenger foot area
and feed it under center of dash on top of metal hump
until it exits over in the driver foot area. Pull all excess
wire over and leave it there for now and let’s move
on to both the Amp Remote Wire and the Remote Bass
Level Controller.
It’s a good idea to first decide where you want to install
the Remote Bass Level Controller. You don’t want to
actually screw it in place yet, just find a place you’ll want it.
Shown is a good spot in the later model JK Unlimited, for
example. Earlier ‘07-’10 models can have similar placement.
Taking time to properly mark where the screw holes will go
with a pencil, pick-all, etc. will go a long way and ensure
you’re happy with its’ location and function for many years.
s
a
g
oo
did
ea
t
o
fi
rs
t
decide
w
he
re
y
ou
w
an
t
to
i
ns
ta
ll
9