Owner's Manual

Last is to run the speaker wire over to your amplifier,
located under the driver seat. As the wire exits the
pod it’s easiest to tuck it up under the center console…
…and bring it up basically at the other side of the
console. In this photo, we’ve opted to cut slits
in the carpet so all wires exit right at the point
they connect to the amplifier.
Now it’s time to do some sound tests. Be sure to listen to a variety
of music and remember that songs played from an FM station versus
ones from CD or MP3 won’t sound quite as good because the signal
is being pulled in from the airwaves, not produced internally. If
you got the Neo-Pod with Kicker amp and sub (#31649KL), you’ll find
that remote bass level controller you installed on the dash is awesome
and will use it a lot. If you are using your own amp and it’s equipped
to take a remote bass controller, it is highly recommended. (Much
better than relying only on the bass adjustments that can be done
with the head unit alone.)
Select Increments
610-345-9044 (no texts)
Email: [e-mail]