Owner's Manual

We’re going to start with the forward screw first.

In photo, left hand is gently pushing pod forward,

toward front of vehicle, while right hand is gently

pushing pod toward driver seat. This is how to get

pod in place for the front screw. Carpet in area

under right hand may move toward front of vehicle

somewhat, so may need to use palm to hold it back.

Using a 3/8” hex drive and a small extension, run screw

through carpet and metal floor. Expect the back of the

pod to rise up some as this screw is tightened. Don’t

over-tighten, as the metal floor is not super-thick.

You won’t see screw come through anywhere underneath

jeep because there’s a hollow area and then another

layer of metal it doesn’t go through.

With the front screw in, the pod needs to be

centered between the seat legs (arrows).

Right rear leg screw is next. This one goes

in much like the front one did.

Last screw is the left rear leg. This one will feel a little different than the others because it goes through two different

layers of metal spaced slightly apart. The photo shows the screw coming through the second layer. The hollow area

in the shadow above is hiding the first layer (the metal your carpet is resting on). So, you’ll feel the screw go through

that metal, hit and stop at the next layer. Keep drilling and it’ll go through.

3 4