Owner's Manual

ManualsBrandsSelect Increments ManualsCar Audio & VideoJLJT-Pods

Attach the included peel-and-

stick foam gasket pieces around

the bottom of the pods as shown

for an airtight seal. Cut any excess

so the ends meet but don’t overlap.

Remove the sound bar grilles with

torx T-30 driver or 5mm Allen driver.

You’ll reuse these factory screws

to attach the pods so keep them.

Continued… after tweeters have been installed in the pods…

Type 2 installation for premium Alpine® systems #30-JLJT-AE and #31-JLJT-AKC:

PAGE 5

Remove factory woofers and tweeters

with a torx T-20 driver and disconnect

the speakers. Run all screws for both

speakers back into sound bar tightly.

Connect tweeters to smaller factory plugs in

sound bar. Tuck extra wire into original smaller

speaker recesses in sound bar. To attach pods:

push down on the pods so the gaskets compress

(particularly on each end where the screws are

further apart to gain thread purchase) and

attach the pods using a torx T-30 Driver or 5mm

Allen Driver and the factory screws from the

factory sound bar grilles. Or use the included

longer screws & washers (maybe only

temporarily) if you can’t catch the threads in

the sound bar.

Connect the supplied connectors with the

factory connectors. Center the speakers

and grilles and attach them with the

screws that came with your speakers.

Start with a drill, but hand-tighten until

snug with a screwdriver. (30-JLJT-AE see

bullet point, page 3 if you didn’t

already, please).

Remove the foam pieces and then remove

the plastic port tubes with a torx T-30

driver and pull off the rubber gaskets, then

put all the screws back in place tightly.

Remove foam pieces.

IF NECESSARY

Once in a while a small gap between

the gasket and sound bar can happen

here. Running a small screw, about ¾”

in length, through the pod where shown

and into the sound bar on the edge here

will cinch it down and close the gap.

TEST FIT: Attach the supplied connectors to the spade terminals on the speakers. Put

the speakers in the pods and see how you want the speakers and grilles oriented

(logos, desired appearance etc.) and see if you have to bend the speaker spade

terminals for clearance so the speakers fully drop into the pods. Once you have a

plan, get your drill, screws, speakers & grilles ready and easy to grab.