Owner's Manual

ManualsBrandsSelect Increments ManualsCar Audio & VideoJLJT-Pods

Attach the included peel-and-

stick foam gasket pieces around

the bottom of the pods as shown

for an airtight seal. Cut any excess

so the ends meet but don’t overlap.

Push down on the pods so the gaskets compress

(particularly on each end where the screws are

further apart to gain thread purchase) and

attach the pods using a torx T-30 Driver or 5mm

Allen Driver and the factory screws from the

factory sound bar grilles. Or use the included

longer screws & washers (maybe only

temporarily) if you can’t catch the threads in the

sound bar.

TEST FIT: Attach the supplied connectors to the spade terminals on the speakers. Put

the speakers in the pods and see how you want the speakers and grilles oriented

(logos, desired appearance etc.) and see if you have to bend the speaker spade

terminals for clearance so the speakers fully drop into the pods. Once you have a

plan, get your drill, screws, speakers & grilles ready and easy to grab.

PAGE 2

Remove the sound bar grilles with a

torx T-30 driver or 5mm Allen driver.

You’ll reuse these factory screws

to attach the pods so keep them.

Remove the factory woofers and tweeters

with a torx T-20 driver and disconnect the

speakers. Tuck the smaller tweeter connectors

in the alcoves and tape or zip-tie them to

themselves so they don’t rattle since they

are not used. Run all screws for both

speakers back into sound bar tightly.

Connect the supplied connectors with

the factory connectors. Center the

speakers and grilles and attach them with

the screws that came with your speakers.

Start with a drill, but hand-tighten until

snug with a screwdriver. (28-JLJT-E see

Page 1 “Before we start” section if you

didn’t already, please).

Type 1 Installation for 28-JLJT-E and 29-JLJT-K

Once in a while a small gap between

the gasket and sound bar can happen

here. Running a small screw, about ¾”

length, through the pod where shown

and into the sound bar on the edge here

will cinch it down and close the gap.

Remove the foam pieces and then

remove the plastic port tubes with

a torx T-30 driver and pull off the

rubber gaskets, then put all the

screws back in place tightly.

Remove foam pieces.

IF NECESSARY