Operator`s manual

46 TESTER
3. .Touch the probe tip to the metal surface of any of the
connectors on the base of the Tester.
ACTIVE KEY
e If the display does not change, the Auto-
probe has failed the Self-Test. Press
e to return to the SELF-TEST
MENU.
4. “PASSED” is displayed if the Autoprobe is functioning properly. “FAILED” is
displayed if the e key was pressed in Step 3. Press x to return to the
SELF-TEST MENU.
ACTIVE KEY
x Returns to the SELF-TEST MENU.
RS232
Press 7 to select the RS232 test from the SELF-TEST MENU. The RS232 test checks
for proper operation of the RS232 Port.
1. Install the RS232/IP Self-Test Adapter. The Tester checks the RS232 Port.
ACTIVE KEY
e Runs the test.
The RS232 TEST result is displayed.
ACTIVE KEY
x Returns to the SELF-TEST MENU.
CONNECTOR METAL
SURFACE
NOTE
When this test is selected, you are instructed to install the
RS232/IP Self-Test Adapter in the RS232 Port.