Operating instructions

-73-

Printer jet test
This test is done when the printing of sheets is not possible, is not clear. ( This test will be
conducted only when stacker unit and printer unit are installed. )
1.
Press the
MENU
switch to enter the menu mode.
2.
Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3.
Use the
UP
and
DOWN
switches to select [Printer Jet Test].
4.
Press the
FEED/ENTER
switch to confi rm the selection and display [PJet Test Start = Start].
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
5.
Press the
FEED/ENTER
switch to do Printer jet test one time.(about 2.5 sec.)
(When Printer jet test ends , the fl ashing “

” mark disappears from the LCD.)
6.
Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Note)
You cannot return to normal mode while the test is running.
Operating tests

Printer jet test
SR-3565(E).indd 73SR-3565(E).indd 73 2007-8-16 10:20:462007-8-16 10:20:46