Operating instructions

-70-
Operating tests
This section explains operating test procedures.

Feed test 1
This test reads the check sheets included in the package to test if the device reads them
properly.
If the device doesn’t read the check sheets properly, the reading test will stop.
Once reading of the check sheets starts, the test will continue until an error occurs or the
hopper is empty.
1.
Press the
MENU
switch to enter the menu mode.
2.
Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3.
Use the
UP
and
DOWN
switches to select [Feed Test 1].
4.
Press the
FEED/ENTER
switch to confi rm the selection and display [Feed Test 1].
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
5.
Use the
UP
and
DOWN
switches to select the setting value.
6.
Press the
FEED/ENTER
switch to start/stop feed test 1.
(The fl ashing “

” mark disappears from the LCD, and the test will start/stop.)
7.
Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Note)
• You cannot return to normal mode while the test is running.
• If a reading error occurs on both sides of a sheet, the error count will
be two.
• If the stacker unit is installed and an error occurs, paper will be
transfered to the selection tray.
Feed test 1 setting values
• Stop • Start
Operating tests

Feed test 1
SR-3565(E).indd 70SR-3565(E).indd 70 2007-8-16 10:20:382007-8-16 10:20:38