Operating instructions

ManualsBrandsSekonic ManualsComputer equipmentSR-6500

-42-



Setting density balance

You can set the density balance level when using the SR-600/SR-9000 operating mode.

Density balance can be set so that when marks are read, marks lighter than the set density

balance will be ignored, and marks darker than the set density balance will be detected.

Density balance can be set from 1 to 15.

Press the

switch to enter the menu mode.

Use the

and

DOWN

switches to select the following parameters,

and press the

FEED/ENTER

switch.

Use the

and

DOWN

switches to select [Density Balance] setting,

and press the

FEED/ENTER

switch.

(“



” mark ﬂ ashes in the ﬁ rst column of the ﬁ rst line on the LCD.)

Use the

and

DOWN

switches to set the value.

Press the

FEED/ENTER

switch to save the setting value into memory.

(The ﬂ ashing “



” mark disappears from the LCD.)

Keep pressing the

CLEAR/EXIT

switch until it returns to normal mode,

or press the

switch to return to normal mode.

Note)

See the operating manual of each type in regard to density balance.

Density balance

setting values

1 - 15

Data reading settings



Setting density balance

SR-3565(E).indd 42SR-3565(E).indd 42 2007-8-16 10:19:352007-8-16 10:19:35