Operating instructions

-41-
SR-3500
SR-6500
min. density
level
SR-600
SR-9000
mode
min. density
level
SR-3500
SR-6500
min. density
level
SR-600
SR-9000
mode
min. density
level
SR-3500
SR-6500
min. density
level
SR-600
SR-9000
mode
min. density
level
1 1 7 5~6 12 10~11
2 1~2 8 6~7 13 10~11
3 2~3 9 7~8 14 11~12
4 3~4 10 8~9 15 12~13
5 4~5 11 9~10 16 13~14
6 5~6

Setting min. density level
You can set the min. density level for this device when it is in SR-600/SR-9000 operating
mode. Sensitivity levels range from 1 to 16, with level 1 being the maximum sensitivity and
level 16 the lowest sensitivity.
1. Press the
MENU
switch to enter the menu mode.
2. Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3. Use the
UP
and
DOWN
switches to select [Min. Density Level] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4. Use the
MENU
and
DOWN
switches to set the value.
5. Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
6. Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Min. density level
setting values
1 - 16
*1. The above sensitivity level is a standard table under a complete marked
mark of grid width for 3mm in 105g/m2 paper thickness.
*2. The sensitivity level varies depending on marks because reading method is
different each other.
*3. When you use this device in compatible mode, the verification by you is
necessary .
Data reading settings

Setting min. density level
SR-3565(E).indd 41SR-3565(E).indd 41 2007-8-16 10:19:332007-8-16 10:19:33